CV Thermostat Error Codes
CV Temperature Control/ Thermometer Set Up Sheet 10/10/07sb Correct Settings CAL = -5° / TC = H / HYS = 5° Calibration Offset (CAL) – The correct setting...
Troubleshooting
-
CV Thermostat Error Codes
-
Southern Pride 582019 Burner Ignition Control Spark Module LED Light Codes
Southern Pride 582019 Burner Ignition Control Spark Module LED Light Codes
When it comes to your Southern Pride smoker, understanding the meaning behind the burner ignition control module light codes is crucial for proper maintenance and troubleshooting. Each light code indicates...
-
Vibrating convection motor? Don't forget to check your motor bushings!
Vibrating convection motor? Don't forget to check your motor bushings!
If you have a vibrating convection motor just replacing the fan blade may not resolve your issue completely. Check the shaft of the motor where it feeds through the wall...
-
Replacing Lesson Convection Motor Rubber Shaft Bushing
Replacing Lesson Convection Motor Rubber Shaft Bushing
If your convection fan motor is shaking badly you either have a dirty fan blade, faulty rubber bushing, or bad motor bearings. If the shaft of the motor is moving...
-
Wall Plug or Breaker Box Trip When Open Doors
Wall Plug or Breaker Box Trip When Open Doors
If your GFCI or breaker box breaker are tripping when you open up the meat doors of your smoker you likely are having an issue with either the interior light...
-
Mechanical Thermostat Rotisserie Only Working With Foot Pedal
Mechanical Thermostat Rotisserie Only Working With Foot Pedal
If you're Southern Pride smoker with a mechanical thermostat is working fine except the rotisserie will not work except by using a foot pedal you likely have a faulty NC (Normally...
-
BMJ BMJ-1000 High Limit With Capilary Tube
BMJ BMJ-1000 High Limit With Capilary Tube
Some very old smokers came equipped with a high limit that used a capillary tube which is no longer available. This can be replaced with bi-metal high limit assembly found...
-
Old Style Smoke Extractor Linkage System Configuration
Old Style Smoke Extractor Linkage System Configuration
Attached images show the setup of the old style smoke extractor damper linkage system arms.
-
Test Flame Sensor On Burner Control Module
Test Flame Sensor On Burner Control Module
Want to test if your flame sensor is flame sensing on your Southern Pride gas smoker? To check if your ignition electrode flame sensor is functioning properly check for 1.5...
-
Test Rotisserie Advance Button
Test Rotisserie Advance Button
To test for a faulty rotisserie advance button test for 120v across the N/O block on the back of the switch. When you push the button you should get 120v,...
-
No Power to Smoke Extractor
No Power to Smoke Extractor
When you open the doors you can check the clear relay that does NOT have a red wire. You should have 120v across the coil A & B, and when...
-
Replacing old thermostat 1006 with new digital thermostat 432001
Replacing old thermostat 1006 with new digital thermostat 432001
As of 01/16/07 the old part number 1006 thermostat is no longer be available, it has been replaced by part number 432001 digital temperature control. This change is being made to provide better...
-
What does the "B Fail" Error Mean?
What does the "B Fail" Error Mean?
A "B Fail" error on your thermostat means your burner attempted to ignite for 3 full cycles without success. The burner control module generally displays a flashing fault code to...