Cook & Hold Thermostat Error Messages
Cook & Hold thermostat displaying an error message? Find out more by reading this service bulletin. Service Bulletin SP2018-001.0
Contact US | About Us | Cart | My Account | Apply for financing. Learn more
17 lenders are ready to fight for your business
How much money would you lose if your smoker went down?
Cook & Hold thermostat displaying an error message? Find out more by reading this service bulletin. Service Bulletin SP2018-001.0
When it comes to your Southern Pride smoker, understanding the meaning behind the burner ignition control module light codes is crucial for proper maintenance and troubleshooting. Each light code indicates...
If you have a vibrating convection motor just replacing the fan blade may not resolve your issue completely. Check the shaft of the motor where it feeds through the wall...
If your convection fan motor is shaking badly you either have a dirty fan blade, faulty rubber bushing, or bad motor bearings. If the shaft of the motor is moving...
If your GFCI or breaker box breaker are tripping when you open up the meat doors of your smoker you likely are having an issue with either the interior light...
This must be done for mirror image units to make the drive run the correct direction. Chain Driven System: On gearmotor part # 351001 reverse wires T5 & T8 On...
Want to test if your flame sensor is flame sensing on your Southern Pride gas smoker? To check if your ignition electrode flame sensor is functioning properly check for 1.5...
To remove your smokers firebox you must first remove the burner assembly, and then unbolt the firebox bolts and the whole box will slide out of the unit.
Door prox switch is stuck closed, or the relay is stuck closed. If you drop the magnetic door switch, and look at the red indicator light on the prox switch...
To test for a faulty rotisserie advance button test for 120v across the N/O block on the back of the switch. When you push the button you should get 120v,...
Open the damper to its open position and also turn on the actuator motor so it goes to its fully open position. Once the motor is in the fully open...
When you open the doors you can check the clear relay that does NOT have a red wire. You should have 120v across the coil A & B, and when...