CV Thermostat Error Codes
CV Temperature Control/ Thermometer Set Up Sheet 10/10/07sb Correct Settings CAL = -5° / TC = H / HYS = 5° Calibration Offset (CAL) – The correct setting...
Contact US | About Us | Cart | My Account | Schedule Service | Apply for financing. Learn more
17 lenders are ready to fight for your business
How much money would you lose if your smoker went down?
Call Today To Schedule Your Maintenance or Repair
CV Temperature Control/ Thermometer Set Up Sheet 10/10/07sb Correct Settings CAL = -5° / TC = H / HYS = 5° Calibration Offset (CAL) – The correct setting...
When it comes to your Southern Pride smoker, understanding the meaning behind the burner ignition control module light codes is crucial for proper maintenance and troubleshooting. Each light code indicates...
If you have a vibrating convection motor just replacing the fan blade may not resolve your issue completely. Check the shaft of the motor where it feeds through the wall...
If your convection fan motor is shaking badly you either have a dirty fan blade, faulty rubber bushing, or bad motor bearings. If the shaft of the motor is moving...
If your GFCI or breaker box breaker are tripping when you open up the meat doors of your smoker you likely are having an issue with either the interior light...
If you're Southern Pride smoker with a mechanical thermostat is working fine except the rotisserie will not work except by using a foot pedal you likely have a faulty NC (Normally...
Attached images show the setup of the old style smoke extractor damper linkage system arms.
This must be done for mirror image units to make the drive run the correct direction. Chain Driven System: On gearmotor part # 351001 reverse wires T5 & T8 On...
Want to test if your flame sensor is flame sensing on your Southern Pride gas smoker? To check if your ignition electrode flame sensor is functioning properly check for 1.5...
To remove your smokers firebox you must first remove the burner assembly, and then unbolt the firebox bolts and the whole box will slide out of the unit.
Door prox switch is stuck closed, or the relay is stuck closed. If you drop the magnetic door switch, and look at the red indicator light on the prox switch...