Apply for B2B Financing

17 lenders are ready to fight for your business

Shop Emergency Repair Kits

How much money would you lose if your smoker went down?

Schedule Service

Call Today To Schedule Your Maintenance or Repair

Digital Cook & Hold Digital Thermostat Programming Instructions

Coby Poluk |

CONTROL OPERATING INSTRUCTIONS 

1. The product loading doors must be closed.

2. The control should be in the “IDLE” mode. (The burner, convection fan, and the rotisserie will be off). If the control is “OFF” a press of any button will bring the control back to “IDLE.”

3. A menu consists of a cook temperature, cook time, and, when the cook time has elapsed, a choice to end the menu (HOLD OFF) or go into hold mode (HOLD TEMP SETPOINT).

4. Press the cook temp button (tEnP 1 will appear in the LED display), then press the up/down buttons to obtain the desired cook temperature.

5. Press the cook time button (tinE1 will appear in the LED display), then press the up/down buttons to obtain the desired cook time.

6. Press the hold temp button (HtEnp will appear in the LED display), press the up/down buttons to obtain the desired hold temp, if a hold temp is not desired press the down button until “OFF” is displayed in the LED.

7. Programming the menu is complete. To start the menu, press the start/stop button one time. The control will begin the menu.

8. To cancel or stop the menu, press and hold the start/stop button until “IDLE” is displayed in the LED.

9. When the cook cycle is complete there are two possible actions that can be taken. One is if a hold temperature was programmed into the menu, the control will momentarily sound an audible alarm then, “HOLD” and the length of time the control has been in the hold mode will alternately flash in the LED display. The control will maintain the hold temperature until the start/stop button is depressed to “END” the menu, and bring the control to the “IDLE” mode.

10. If the hold temperature was programmed to “OFF” and the cook time has elapsed, “END” will be displayed on the LED display, and an audible alarm will sound continuously until the start/stop button is depressed, to “END” the menu, and bring the control to the “IDLE” mode.

11. After the control has been in the “IDLE” mode for five minutes it will go to “OFF”, a press of any button will bring the control back to “IDLE”.

Leave a comment

Please note: comments must be approved before they are published.