Cook & Hold Thermostat Error Messages
Cook & Hold thermostat displaying an error message? Find out more by reading this service bulletin. Service Bulletin SP2018-001.0
Troubleshooting
-
Cook & Hold Thermostat Error Messages
-
Southern Pride 582019 Burner Ignition Control Spark Module LED Light Codes
Southern Pride 582019 Burner Ignition Control Spark Module LED Light Codes
When it comes to your Southern Pride smoker, understanding the meaning behind the burner ignition control module light codes is crucial for proper maintenance and troubleshooting. Each light code indicates...
-
Vibrating convection motor? Don't forget to check your motor bushings!
Vibrating convection motor? Don't forget to check your motor bushings!
If you have a vibrating convection motor just replacing the fan blade may not resolve your issue completely. Check the shaft of the motor where it feeds through the wall...
-
Replacing Lesson Convection Motor Rubber Shaft Bushing
Replacing Lesson Convection Motor Rubber Shaft Bushing
If your convection fan motor is shaking badly you either have a dirty fan blade, faulty rubber bushing, or bad motor bearings. If the shaft of the motor is moving...
-
Wall Plug or Breaker Box Trip When Open Doors
Wall Plug or Breaker Box Trip When Open Doors
If your GFCI or breaker box breaker are tripping when you open up the meat doors of your smoker you likely are having an issue with either the interior light...
-
Test Flame Sensor On Burner Control Module
Test Flame Sensor On Burner Control Module
Want to test if your flame sensor is flame sensing on your Southern Pride gas smoker? To check if your ignition electrode flame sensor is functioning properly check for 1.5...
-
Firebox Removal
Firebox Removal
To remove your smokers firebox you must first remove the burner assembly, and then unbolt the firebox bolts and the whole box will slide out of the unit.
-
Rottiserie, Burner, Convection Do NOT Stop With Doors Opened
Rottiserie, Burner, Convection Do NOT Stop With Doors Opened
Door prox switch is stuck closed, or the relay is stuck closed. If you drop the magnetic door switch, and look at the red indicator light on the prox switch...
-
Procedure To Properly Set The Set Screw On Your Smoke Extractor Damper Motor
Procedure To Properly Set The Set Screw On Your Smoke Extractor Damper Motor
Open the damper to its open position and also turn on the actuator motor so it goes to its fully open position. Once the motor is in the fully open...
-
No Power to Smoke Extractor
No Power to Smoke Extractor
When you open the doors you can check the clear relay that does NOT have a red wire. You should have 120v across the coil A & B, and when...
-
Diagnose No Power To CV Thermostat
Diagnose No Power To CV Thermostat
**NOTICE** All repairs should be performed by a certified technician. Southern Pride of Texas® is not liable for any damges, or injury if you choose to attempt repairs on your...
-
Smoker w/ CV Thermostat | Smoker Will Not Turn Off
Smoker w/ CV Thermostat | Smoker Will Not Turn Off
If you cannot turn your smoker off using the main power switch then your normally open (NO) contact block may be stuck closed or shorted closed. To verify this you...
-
Digital Cook & Hold Digital Thermostat Programming Instructions
Digital Cook & Hold Digital Thermostat Programming Instructions
CONTROL OPERATING INSTRUCTIONS 1. The product loading doors must be closed. 2. The control should be in the “IDLE” mode. (The burner, convection fan, and the rotisserie will be off)....